دراسة بحثية لإنتاج خرسانة ذاتية الإنارة
DOI:
https://doi.org/10.65405/ff84dm43Keywords:
Strontium Aluminate, Epoxy resin, Glass waste and Titanium dioxideAbstract
Traditional concrete used today in construction is gray in color of high density. And does not permit light to go through if and hence does not glow. To change this characteristic, the chemical composition of concrete needed to be changed by adding substances that have a glowing appearance. These substances are insert and have a minimum effect on environment. After trials, research and depending on luminance results, it was found that the second mixture with additives of (Strontium Aluminate, Epoxy Risen, glass residue and Titanium Dioxide) was the most glowing for the longest period According to pressure resistance, it was found that self-glowing concrete gave comparable results to traditional concrete. Economically, the self-glowing concrete costs only 10% more than traditional concrete. The cost may be considered feasible due to the clean energy it provides. The light omitted lasted from 2 to 5 hours.
Downloads
References
1- M. Yunin, N.A., M. Zulkiffl, N.S., Shabadin, A, and Ishak, S.Z(2018). Effect of Enhanced Road Marking in Road Safty -Speed and Lateral Position. Jouinal of built Environment, Technology and Engineering, Vol.4(May) ISSN 0128-1003
2- Puvanasvaran, A.P., Yop Zain, M.F., Al-Hayali, Z.A. and Mukapit, M. (2012). Sustainability of Green Technology in Malaysia Industry, International Conference on Design and Concurrent Engineering.
3- Green, J., Perkins, C., Steinbach, R. and Edwards, P. (2015). Reduced street lighting at night and health a rapid appraisal of public views in England and Wales. Health & place ,34, PP.171-180.
4- IS EN 1436 A Guide to European Standard for Road Marking, Manual on Uniform Traffic Control Devices.
5- International Gournal of Emerging Trends & Technology in Computer Science (IJETTCS), Volume 7, Issue 2, March- April 2018, Transparent Concret Concept Py Replacing Fine Aggregate of Waste Glass Py Using Admixture in Optical Fipre Dipka G, Kaaviya S, Kavitha Karthikeyan S.
Indhumathi S.
-6 Azouz, A., Fawzi, M., Mohammed, I., Hamed, O., Maher, A., & Baddi, M. (2026). Influence of Electrolyte Chemistry and Electrode Material on Hydrogen Production Performance in Alkaline Water Electrolysis. Al-Farooq Journal of Sciences, 2(2), 49-66.
7- " Glow-in-the-dark cement could revolutionize how we light cities " Jose Carlos Rubio Avalos (2016).
8- " Characteristies of Strontium Aluminate Crystals Used for Long Duration Phosphors " – Tooru Katsumata (2015).
9- Photoluminescence- Advances in Research and Application- Ellis Mardwn.
